Albemarle 410 CONVERTIBLE Owner's Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 138
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
410 Convertible
36
Holding Tank Pump
Supplies electrical current to the macerator pump. This breaker
should be in the “OFF” position except when pumping out the
holding tank.
Horn
Supplies 12-volt electrical current to the horn switch in the
helm switch panel.
Blower
Supplies 12-volt electrical current to the bilge blower switch
in the helm switch panel. Refer to the blower switch in this
chapter and the Ventilation Systems chapter for more informa
-
tion on the blower.
Bilge Lights
Supplies 12-volt electrical current to the bilge light switch for
the aft bilge compartment.
Trim Tabs
Supplies 12-volt electrical current to the trim tab switch on the
helm switch panel.
Head
Supplies electrical current directly to the vacuum pump on
the electric head system. A vacuum switch on the pump au-
tomatically controls the pump and maintains proper vacuum
in the system.
Bilge Lights
Supplies 12-volt electrical current to the bilge light switch for
the forward bilge compartment.
Baitwell
Supplies 12-volt electrical current directly to the livewell pump
pressure switch located on the pump. The pressure switch
automatically controls the water pump when the system is
activated and properly primed. It is protected by the circuit
breaker in the panel and an automatically resetting breaker on
the pump motor.
Livewell
Supplies 12-volt electrical current directly to the livewell pump
pressure switch located on the pump. The pressure switch
automatically controls the water pump when the system is
activated and properly primed. It is protected by the circuit
breaker in the panel and an automatically resetting breaker on
the pump motor.
Stereo
Supplies 12-volt electrical current to the stereo.
Reserved
Reserved for additional DC equipment.
Cable Master
Supplies 12-volt electrical current to the optional Cable Master
control switch located in the cockpit. The Cable Master unit is
used to extend and retract the shore power cable.
Oil Change Pump
Supplies 12-volt electrical current to the switch on the oil
change pump.
Reserved
Reserved for additional DC equipment.
Electronics
Supplies 12-volt electrical current to the electronics.
Spare
Reserved for additional 12-volt equipment.
Spare
Reserved for additional 12-volt equipment.
Additional Breaker Panels:
The following is a description of the accessories controlled
by the “Push to Reset” DC breakers in the battery switch
panel:
Pt Engine Control Breaker
Provides protection and power for the 12-volt circuit to the
port engine electronic control processor. This “push to reset”
breaker is always supplied current when the port engine battery
switch is activated.
Stbd Engine Control Breaker
Provides protection and power for the 12-volt circuit to the
starboard engine electronic control processor. This “push to
reset” breaker is always supplied current when the starboard
engine battery switch is activated.
Batt Condition Starboard
Provides protection and power for the 12-volt circuit to the
battery condition test switch for the starboard engine battery
bank.
Batt Condition Port
Provides protection and power for the 12-volt circuit to the
battery condition test switch for the port engine battery bank.
Batt Condition House
Provides protection and power for the 12-volt circuit to the
battery condition test switch for the port engine battery bank.
Stereo
Provides protection and power for the stereo memory. This
“push to reset” breaker is always supplied current when the
batteries are connected.
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 137 138

Comments to this Manuals

No comments